|
Post by Jeabus on Dec 3, 2010 15:24:13 GMT -5
Hey Maverick. I have been to the airhouse once and my gun shot over 350. So I got a 90 rated spring and tried to install it into my G&G Combat Machine M4. I got it all taken apart and put the new spring in then put it back together. But when I pulled the trigger all that happened was my motor just ran and nothing like a the sound of when it fires happened. I was wondering if you knew what the problem is or if you are going to be at the airhouse tomorrow to maybe take a look at it.
Thanks.
Jeabus (Tom)
|
|
|
Post by Munster on Dec 3, 2010 17:05:08 GMT -5
Hey there, I just sent Maverick a text message for you. Hopefully he will respond!
Also, I deleted your other post because tech discussion belongs in this area only.
|
|
|
Post by Jeabus on Dec 4, 2010 17:03:11 GMT -5
Hey thanks man. Sorry i did not show up today. But i figured out the problem and am taking care of it.
|
|
|
Post by Doc on Dec 7, 2010 9:17:30 GMT -5
This sounds like a few different things
1. You motor is not close enough to the pinion gear to catch and cycle the gears. 2. Check the motor plate and make sure it is screwed in tight and then adject the motor adjustment screw till it catches like it should.
Try these steps and go from there.
|
|